E5AX OMRON PDF

Find great deals for Omron E5ax Temperature Controller E5ax-a-f. Shop with confidence on eBay!. E5AX-VAA Omron Automation and Safety Controllers datasheet, inventory, & pricing. E5AX-A by Omron | OMRON TEMPERATURE CONTROLLER | Shipping to + countries worldwide.

Author: Daikasa Malasida
Country: Uzbekistan
Language: English (Spanish)
Genre: Health and Food
Published (Last): 13 September 2013
Pages: 83
PDF File Size: 7.63 Mb
ePub File Size: 6.18 Mb
ISBN: 463-8-71599-816-3
Downloads: 28698
Price: Free* [*Free Regsitration Required]
Uploader: Nem

HEA In the interest of product improvement, specifications are subject to change without notice. The factory setting is 40 seconds.

Omron E5ax Temperature Controller E5ax-a-f

The count value for the fully open position will be set. The maximum total cable length must not exceed the following moron. Connect a valve position indicator if required. Remove the internal mechanism from the housing. Press the Display Key as soon as the valve stops by the limit switch built into the e5qx. In effect, the Temperature Controller is write-protected and the set values such as the alarm value can be read out only. Error Messages The Temperature Controller is provided with self-diagnostic functions, and will display an error message on the PV display when an error is detected.

Proportional alarm output is OFF, however. Input shift value — fr—l Count value Fully closed position Press a. Moreover, avoid locations subject to heavy vibration or shock, water or oil spray, or high temperatures. Outputs the temperature data within the set limits. Four internal switches must be set on the E5AX: The display level mode changes as shown below.

  GN NETCOM 9120 PDF

Integral Time Reset Time: Manual Output Mode Indicator Lights when in manual output mode. Derivative Time Rate Time: Usually, the alarm value is set as a deviation from the main setting, but it can also be set as an absolute value when the event alarm mode is selected. Level 0 is the initial and is automatically entered at power application.

The factory setting is seconds. Therefore, take this time delay into consideration when designing sequenced circuits which incorporate a Temperature Controller. Potentiometer input see Note 1 Use these terminals when connecting a thermocouple do not remove short bar from terminals 14 and To convert grams into ounces, multiply by 0.

Omron E5ax-ah E5AXAH Temperature Controller C

Press the Display Key to return to sl—l. Recommended panel thickness is 1 to 8 mm. The output value will change according to the difference between the set value and the present value when the proportional band is changed during control operation.

It can be set in a range from 0. The following table shows the messages that may be displayed. All units are in millimeters unless otherwise indicated.

  BB HCM403A PDF

Press the Display Key.

Omron E5ax-ah E5AXAH Temperature Controller C | eBay

The count value for the fully close position will be set. The figures show the locations of these switches and the protection switches on the internal mechanisms. To stop auto-tuning, hold down the Level Key and Mode Key again simultaneously for 1 e5zx minimum.

ON Sends alarm signal in accordance with the set alarm mode.

OMRON E5AX-LA — Hy-Tech Sales, Inc.

Automatic tuning can be executed at any time: Solder-dipped Leads Strip 6 to 12 mm of the lead wires and carefully arrange the wire tips. Compatible with various inputs input selected via internal switch.

The output mode cannot be changed in motor calibration mode. Sequenced Circuits Several seconds are required until the relay in turned ON after power has been supplied to the Temperature Controller. Note 3 al 0 Alarm value Press a. Main setting, set alarm value, process value, error codes, etc. The factory setting is 2. Any of these condition will affect product life.